FOR MORE INFORMATION SCAN BELOW Side: A 45 RPM THE REVOLUTION GO VSC-750SB
Q U I C K S T A R T G U I D E FUNCTION KNOB - BASIC OPERATION POWER: VOLUME: Press and hold for 1-2 seconds to turn the unit ON or OFF. Rotate to raise or lower volume. FUNCTION KNOB - TO CYCLE THROUGH FEATURES VINYL: Press to enter record player function mode. VINYL STREAM: Press to connect the unit to an external Bluetooth speaker. BLUETOOTH: Press to pair the unit with a Bluetooth device (smartphone). OPERATION RING COLOR FUNCTION & VOICE PROMPT POWER ON: Press and hold for 1-2 seconds.
R E V O L U T I O N Top View G O O V E R V I E W 45 RPM Adaptor Lift Lever Turntable Platter Speed / Auto Stop Switches Tone Arm Tone Arm Stylus Speaker Function Knob Rear View Charging LED R Bottom View L CHARGING RESET DC IN 9V RCA Line Out Jack Headphone (3.
R E C O R D H O L D E R L I D 45 REMOVE RECORD FROM UNIT & LOWER THE LID AT A 45º ANGLE APPLY LIGHT PRESSURE TO THE BOTTOM SIDES OF THE LID WHILE LID IS STILL AT 45º, PULL STRAIGHT UPWARD TO REMOVE DOUBLE LP / 2 SINGLE SLOT SINGLE LP SLOT THE LID IS NOW AN AWESOME RECORD HOLDER PLEASE NOTE THE ICONS FOR SINGLE OR DOUBLE LPs FOLLOW THE STEPS ABOVE IN REVERSE TO REATTACH LID G U I TA R S T R A P C A R R Y H A N D L E SLIDE THE CARRY STRAP OVER BOTH SIDE KNOBS MAKE SURE THE STRAP IS SECURE ON EAC
S I M P L E S E T U P GETTING STARTED Remove the needle cover, by gently pulling towards the front of the unit. Carefully plug in the unit and remove any accessories from the platter. Note: It is recommended that this product should be operated only from the type of power source indicated on the power adaptor. BASIC OPERATION Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON or OFF.
V I N Y L P L A Y I N G VINYL: Playing a Vinyl record Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON. Simply press the Function Knob to make sure it is in Vinyl mode (the dial will illuminate white). Remove the needle cover, by gently pulling towards the front of the unit. Select the proper record speed. If using a 45 RPM record, use the included 45 adaptor. Release the Tone Arm from the holder and gently place on the record using the lift lever.
V I N Y L S T R E A M™ VINYL STREAM: Playing a Vinyl record on a external Bluetooth speaker or headphones. Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON. Simply press the Function Knob to make sure it is in Vinyl Stream mode (the dial will flash white). Turn ON your external Bluetooth speaker or headphone, and set to pairing mode. Wait a few seconds for the unit to find your device. The unit will chime and say “Connected”, while the Function Knob will remain white.
W A R N I N G • Always follow basic safety precautions when using this appliance, especially when children are present. • Children should be supervised to ensure that they do not play with the appliance. • Do not damage the power cord, neither do not place any heavy objects on it, do not stretch it or bend it. Also do not attach extension cables. Damage to the power cord may occur fire or electric shock.
W A R N I N G CAUTION: WARNING TIPS OF BATTERY: 1) Risk of explosion if the battery is replaced by an incorrect type; 2) High or low extreme temperatures that a battery can be subjected to during use, storage or transportation; and low air pressure at high altitude.
S A F E T Y I N S T R U C T I O N S POWER ADAPTER: • To disconnect the unit from the main supply, unplug the lead from the main socket. • Only use the supplied main adapter, as failure to do this may result in a safety risk and/or damage to the unit. The main plug of power adapter is used as the disconnect device. The socket-outlet shall be installed near the equipment and shall be easily accessible.
S P E C I F I C A T I O N S GENERAL Power Adaptor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9V/1.5A Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13.5W Power Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 x 5W Operating Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
F C C W A R N I N G S FCC STATEMENTS Caution: the user is cautioned that charges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s).
W A R R A N T Y Victrola is a registered trademark of Innovative Technology Electronics, LLC. United States Victrola (Innovative Technology Electronics, LLC) warrants to the original retail purchaser that this product will be free from defective materials and workmanship for one (1) year from the date of purchase, subject to the limitations below. This warranty period is not extended if we replace the product.
W A R R A N T Y This warranty gives you specific legal rights, and you may also have other rights which vary from state to state, jurisdiction to jurisdiction or country to country. All express and implied warranties for the product, including but not limited to any implied warranties of merchantability and fitness for a particular purpose, are limited in time to the term of this warranty.
Thank you for buying a Victrola.