Owner's Manual

HOW TO REPLACE THE TURNTABLE STYLUS (REPLACEMENT STYLUS # ATN3600L)
Removing the Stylus from the Cartridge
1.
Place your ngers at the tip of the stylus
and push down to the direction “A.
WARNING: When applying force to stylus,
too much may damage or break the cartridge.
2.
Pull the stylus out toward the direction
B
”.
Installing the Stylus
1. Hold the tip of the stylus and insert the other edge
by pressing toward direction “
C
”.
2. Push the stylus up toward direction “
D
until it locks at the tip.
Caution:
Do not remove or bend the stylus needle.
Do not touch the needle to avoid injury to your hand.
Turn off the unit’s power before you replace the stylus.
Keep out of reach of children.
Note: The stylus should last about 300 hours under normal use.
It is recommended that the stylus be replaced as soon as you
notice a change in sound quality. 78 RPM records may accelerate
stylus wear and may have to be changed sooner.
VINYL PLAYING
NEEDLE
REPLACEMENT
VINYL: Playing a Vinyl record
Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON.
Simply press the Function Knob to make sure it is in Vinyl mode (the dial will illuminate white).
Remove the needle cover, by gently pulling towards the front of the unit.
Select the proper record speed. If using a 45 RPM record, use the included 45 adaptor.
Release the Tone Arm from the holder and gently place on the record using the lift lever.
Rotate the Function Knob to adjust the volume if needed.
Note: -Make sure to only touch the center or edges of the record to avoid damage to
the vinyl grooves.
-If no sound is playing, the unit may be in Vinyl Stream mode, cycle through the
function knob to make sure it is in Vinyl mode.
Auto and Manual Stop Selection Switch: If this switch is turned ON, The record will start
spinning when the tone arm moves over the record and the record will stop automatically when
playback is nished. If this switch is OFF, the record will automatically begin to spin when the
unit is in “VINYL” function mode and the record will continue to spin after playback is
nished.
AUTO STOP
ON OFF