Victron VE.Bus Configuration Guide
Table Of Contents
- VictronConnect - VE.Bus Configuration guide
- Table of Contents
- 1. Warning
- 2. Introduction
- 3. Limitations
- 4. Overview Video
- 5. Connecting
- 6. Demo Mode Menu
- 7. Display Options
- 8. Status Mode
- 9. Settings Mode
- 10. Description of Settings
- 10.1. General
- 10.2. Grid
- 10.3. Inverter
- 10.4. Charger
- 10.4.1. Enable charger
- 10.4.2. Charge current
- 10.4.3. Float voltage
- 10.4.4. Absorption voltage
- 10.4.5. Repeated absorption interval
- 10.4.6. Repeated absorption time
- 10.4.7. Maximum absorption time
- 10.4.8. Charge curve
- 10.4.9. BatterySafe
- 10.4.10. Lithium battery mode
- 10.4.11. Storage mode
- 10.4.12. Use equalisation
- 10.4.13. Weak AC input
- 10.4.14. Stop after excessive bulk
- 10.5. AC Input Control
- 11. Firmware Updates
- 12. Parallel, Three, Split-phase systems
- 13. Troubleshooting
9. Settings Mode
You can only access Settings with a MK3-USB. You cannot use a VE.Bus Smart Dongle to access Settings Mode.
Settings is available on Windows, macOS and Android operating systems.
Settings on iPhone is not supported at this time, as iPhone does not support OTG connections from USB and is unable to
connect to the MK3-USB.
VictronConnect - VE.Bus Configuration guide
Page 9 Settings Mode