Victron VE.Bus Configuration Guide
Table Of Contents
- VictronConnect - VE.Bus Configuration guide
- Table of Contents
- 1. Warning
- 2. Introduction
- 3. Limitations
- 4. Overview Video
- 5. Connecting
- 6. Demo Mode Menu
- 7. Display Options
- 8. Status Mode
- 9. Settings Mode
- 10. Description of Settings
- 10.1. General
- 10.2. Grid
- 10.3. Inverter
- 10.4. Charger
- 10.4.1. Enable charger
- 10.4.2. Charge current
- 10.4.3. Float voltage
- 10.4.4. Absorption voltage
- 10.4.5. Repeated absorption interval
- 10.4.6. Repeated absorption time
- 10.4.7. Maximum absorption time
- 10.4.8. Charge curve
- 10.4.9. BatterySafe
- 10.4.10. Lithium battery mode
- 10.4.11. Storage mode
- 10.4.12. Use equalisation
- 10.4.13. Weak AC input
- 10.4.14. Stop after excessive bulk
- 10.5. AC Input Control
- 11. Firmware Updates
- 12. Parallel, Three, Split-phase systems
- 13. Troubleshooting
If the firmware update fails, please attempt it again. If you still cannot recover the unit, Please use the alternative method
and follow these steps using the VEFlash software instead.
11.4. Firmware updates with multiple units (eg 3 phase)
It is possible to use VictronConnect to efficiently update the firmware for 3 phase, or parallel units.
To do this, the units must already be programmed for their multiple unit configuration and connected to each other.
Units will be returned to factory default settings once the firmware update is complete. So make sure that settings and parameters
are saved, and you will also need to reprogram them for their multiple unit configuration (as is covered in the 3 phase and parallel
documentation).
https://player.vimeo.com/video/373208468
VictronConnect - VE.Bus Configuration guide
Page 21 Firmware Updates