Victron VE.Bus Configuration Guide
Table Of Contents
- VictronConnect - VE.Bus Configuration guide
- Table of Contents
- 1. Warning
- 2. Introduction
- 3. Limitations
- 4. Overview Video
- 5. Connecting
- 6. Demo Mode Menu
- 7. Display Options
- 8. Status Mode
- 9. Settings Mode
- 10. Description of Settings
- 10.1. General
- 10.2. Grid
- 10.3. Inverter
- 10.4. Charger
- 10.4.1. Enable charger
- 10.4.2. Charge current
- 10.4.3. Float voltage
- 10.4.4. Absorption voltage
- 10.4.5. Repeated absorption interval
- 10.4.6. Repeated absorption time
- 10.4.7. Maximum absorption time
- 10.4.8. Charge curve
- 10.4.9. BatterySafe
- 10.4.10. Lithium battery mode
- 10.4.11. Storage mode
- 10.4.12. Use equalisation
- 10.4.13. Weak AC input
- 10.4.14. Stop after excessive bulk
- 10.5. AC Input Control
- 11. Firmware Updates
- 12. Parallel, Three, Split-phase systems
- 13. Troubleshooting
1. Warning
The features described in this document are powerful tools. They are intended for use by Victron-trained
Engineers, Installers and Dealers. Its usage must not be attempted by system Owners and Users.
Configuring our Inverter/chargers, such as Multis and Quattros, requires both training and experience.
Victron offers no direct support for un-trained individuals carrying-out configuration.
Settings are protected by a password. This password is provided with Victron training. Please contact your
Victron Distributor for further information.
VictronConnect - VE.Bus Configuration guide
Page 1 Warning