Victron VE.Bus Configuration Guide
Table Of Contents
- VictronConnect - VE.Bus Configuration guide
- Table of Contents
- 1. Warning
- 2. Introduction
- 3. Limitations
- 4. Overview Video
- 5. Connecting
- 6. Demo Mode Menu
- 7. Display Options
- 8. Status Mode
- 9. Settings Mode
- 10. Description of Settings
- 10.1. General
- 10.2. Grid
- 10.3. Inverter
- 10.4. Charger
- 10.4.1. Enable charger
- 10.4.2. Charge current
- 10.4.3. Float voltage
- 10.4.4. Absorption voltage
- 10.4.5. Repeated absorption interval
- 10.4.6. Repeated absorption time
- 10.4.7. Maximum absorption time
- 10.4.8. Charge curve
- 10.4.9. BatterySafe
- 10.4.10. Lithium battery mode
- 10.4.11. Storage mode
- 10.4.12. Use equalisation
- 10.4.13. Weak AC input
- 10.4.14. Stop after excessive bulk
- 10.5. AC Input Control
- 11. Firmware Updates
- 12. Parallel, Three, Split-phase systems
- 13. Troubleshooting
6. Demo Mode Menu
You can learn more about VictronConnect using the demo menu option. This option allows you to load a “demo” device which
simulates a real system. You can then adjust the settings/options. An in-app description in provded for some settings.
There is a choice of demo devices:
To access demo mode, select the three bar icon at the top left of the device list. Then Demo library.
Scroll through the options and then click or tap your selection.
It is possible to save the configuration you have made in demo mode, and load it into a real device.
VictronConnect - VE.Bus Configuration guide
Page 6 Demo Mode Menu