MultiPlus-II 24/3000/70-50 2x120V Manual
Table Of Contents
- MultiPlus-II 12V 3kVA 2x120V
- Table of Contents
- 1. IMPORTANT SAFETY INSTRUCTIONS - Save these instructions!
- 2. Description
- 3. Operation
- 4. Installation
- 4.1. Location
- 4.2. Connection of battery cables
- 4.3. Connection of the AC cabling
- 4.4. Optional Connections
- 4.4.1. Remote Control
- 4.4.2. Programmable relay
- 4.4.3. Programmable analog/digital input/output ports
- 4.4.4. Starter battery (connection terminal E, see appendix A)
- 4.4.5. Voltage sense (connection terminal J, see appendix A)
- 4.4.6. Temperature sensor (connection terminal J, see appendix A)
- 4.4.7. Parallel Connection
- 4.4.8. Three-phase operation
- 5. Configuration
- 6. Maintenance
- 7. Error Indications
- 8. Technical Specifications
- Appendix A. APPENDIX A: Connection overview
- Appendix B. APPENDIX B: Block diagram
- Appendix C. APPENDIX C: Parallel connection
- Appendix D. APPENDIX D: Three phase connection
- Appendix E. APPENDIX E: Charge algorithm
- Appendix F. APPENDIX F: Temperature compensation
- Appendix G. APPENDIX G: Dimensions
- Appendix H. APPENDIX H: Power flow diagrams
PowerAssist
The AC input is switched through, but the load requires more
current than the preset maximum input current. The inverter is
switched on to supply the required additional current. The "mains
on" LED is on and the "inverter" LED is blinking.
For more error codes see section 7.3
For the latest and most up to date information about the
blink codes, please refer to the Victron Toolkit app.
Click on or scan the QR code to get to the Victron Support
and Downloads/Software page.
MultiPlus-II 12V 3kVA 2x120V
Page 8 Operation