Installation

Last update: 2019-08-15 11:42 ccgx:start https://www.victronenergy.com/live/ccgx:start

https://www.victronenergy.com/live/ Printed on 2019-08-15 12:22

Other notes:

In order to work with the CCGX an MPPT 150/70 needs run ﬁrmware v2.00 or newer.1.

You can combine a Skylla-i control panel with a CCGX.2.

You can combine a Ion Control panel with a CCGX.3.

The Skylla-i, Lynx Shunt VE.Can, Lynx Ion + Shunt and the MPPTs with a VE.Can port all power4.

the VE.Can network …so it won't be necessary to power the VE.Can network separately in these

circumstances. All the protocol converters - for example the VE.Bus to VE.Can interface; and the

BMV to VE.Can interface, do not power the VE.Can network.

1.4.4 BMV-600 series

Connect the BMV-600 using the VE.Direct to BMV-60xS cable supplied. (ASS0305322xx)

1.4.5 DC Link box

Connect the DC Link box, using the RJ-12 cable supplied. Then connect the BMV-700 to the CCGX -

see 1.2.2 above for instructions.

1.2.6 VE.Can Resistive Tank Sender Adapter

See its page and manual on our website for details about the Adapter.

To connect a product with a VE.Can port, use a standard RJ45 UTP cable.

Don't forget to terminate the VE.Can network on both ends using a VE.Can terminator. A bag with two

terminators is supplied with each VE.Can product. They are also available separately

(ASS030700000). (Available with straight or elbow connectors.)

Make sure that the canbus is powered, see the Power chapter in the Tank Sender Adapter manual for

details.

1.4.7 NMEA Tank senders from other manufacturers

A tank sender must meet the following requirements to be visible on the CCGX:

Transmit the NMEA2000 Fluid Level PGN, 127505

The NMEA2000 device class needs to be 'General', 80

The NMEA2000 function needs to be 'Transducer', 190

Since v2.17 the following functions are accepted as well:

The NMEA2000 device class 'General', 80 and function 'Sensor', 170

The NMEA2000 device class 'Sensors', 75 and function 'Fluid Level', 150

A single function reporting multiple Fluid Levels is currently not supported.