Cerbo GX Manual

Configuration of the sensor

Normally, the Sensor should work out of the box. In case it does not, for example when the sensor has previously been used in

another system, then:

1. Download the Si-MODBUS-Configuration software tool from the IMT website.

2. Configure the following settings: Modbus Address - 3, Baud Rate: 9600, Data Format: 8N1 (10 Bit): which are all the default

settings as when shipped by IMT.

For more support on configuring the IMT sensor, please contact IMT.

Connecting only an IMT temperature sensor

Both RS485-MB single temperature sensors of IMT are compatible too.

The Tm-RS485-MB will be visible as the 'Cell temperature'.

The Ta-ext-RS485-MB will be visible as the 'External or ambient temperature'

Connecting multiple IMT sensors

It's possible to connect multiple IMT sensors. A separate USB to RS485 converter cable is required for each sensor.

You can't combine multiple Si-Sensor RS485 sensors on one bus, our software supports only one. To use multiple sensors, you

will also need to add multiple USB to RS485 converters.

Usage

This picture shows how its visualised on VRM:

Cerbo GX Manual