Product Manual

4. Installation
4.1. General
• Mount vertically on a non-flammable surface, with the power terminals facing downwards. Observe a minimum clearance of 10
cm under and above the product for optimal cooling.
• Mount close to the battery, but never directly above the battery (in order to prevent damage due to gassing of the battery).
4.2. Connection setup for DC-DC converter mode
1. Disconnect the remote on/off (remove wire bridge).
2. Connect the input supply cables.
3. Open the VictronConnect App to setup the product. (always adjust the output voltage before connecting in parallel or
connecting a battery)
4. Connect the load. The converter is now ready for use.
5. Reconnect the remote on/off to activate the product.
Figure 1: Typical connection setup as DC-DC converter
4.3. Connection setup for charger mode
1. Disconnect the remote on/off (remove wire bridge).
2. Connect the input supply cables.
3. Open the VictronConnect App to setup the product. (always setup the correct charger algorithm before connecting a
battery)
4. Connect the battery to be charged.
5. Reconnect the remote on/off to activate the product.
Orion-Tr Smart DC-DC Charger Non-Isolated
Page 4 Installation