Product Manual

4.6. Install the optional SmartSolar Control display
To install the optional SmartSolar Control display follow these steps:
1. Remove the two screws of the plastic cover. Keep the screws, they are needed again when securing the display.
2. Remove the plastic cover. The display terminal is now exposed.
3. Remove the two plastic plugs on either side of the display plug.
4. Remove the paper backing of the double sided tape on the back of the display.
5. Insert the display into the plug and make sure it has been inserted all the way in.
6. Screw the display down by using the two screws that were used for the plastic cover.
How and where to connect the SmartSolar Control display
For more information, see the SmartSolar Control display manual
The display is hot-swappable, this means that the display can be plugged in or removed while the solar
charger is operating.
4.7. Connect the MPPT Control display
Connect the (optional) MPPT Control display to the VE.Direct port of the solar charger using a VE.Direct cable.
Note that it is not possible to extend the VE.Direct cable, the maximum length can not exceed 10 meter.
For more information, see the MPPT Control display manual
MPPT solar charger manual
Page 12 Installation