Product Manual

3. Control and Adjustment
When the charger is installed correctly, the charger should be set up to suit the battery connected.
To set up the charger, apply mains power and enter the setup menu by pressing “SETUP” for three seconds.
The charger will enter a standby mode (no power applied to the battery terminals) and the user can set up the unit accordingly.
See the next table for all possible adjustments.
3.1. Monitor menu
The monitor menu is visible when power is applied to the charger.
The following table shows the consecutive lines when scrolling through the menu with the up/down keys:
Displayed info Icons Segments Units
Battery voltage / current
14 0
A
Battery voltage
14.40
V
Battery charge current
60.00
A
Battery temperature
*1
25.0,---,Err
°C/°F
Mains current
1C 3.6
A
Battery voltage out 1
*2
1 14.4
V
Battery charge current out 1
*2
1 60.0
A
Battery voltage out 2
*2
2 14.4
V
Battery charge current out 2
*2
2 60.0
A
Battery voltage out 3
*2
3 14.4
V
Skylla-IP65
Page 6 Control and Adjustment