Specifications

BT1/BT2 Bluetooth BT4.0 mode, respectively, is a white light.
Note: In 2.4G mouse mode, when the mouse is used normally, the white indicator light will flash at intervals of about 3
seconds.
； As an indication of the signal light；
In BT1/BT2 Bluetooth mode, when the mouse is used normally, the white indicator light will flash at intervals of
about 3 seconds.； As an indication of the signal light。
1.4 Re-pairing distance
1.4.1Re-pairing distance 30~50cm
Mouse re-pairing 2.4G receiver mode method: first turn on the power toggle switch ON/OFF to the ON position,
then use both hands to simultaneously hold down the mouse: left button L+ middle button M+ right button R for
about 5~8 seconds, then release, Re-insert the USB receiver within 20 seconds. After the mouse pairing is successful,
it can be used normally. If you can't connect again, you can repeat the operation twice to ensure the correct
operation.
BT1 and BT2 Bluetooth: Pair the device, press and hold the switch mode button. When the white light is on, press the
switch mode button for about 5 seconds. The white light flashes quickly and enters the matching mode of the search
device. (Premise to confirm that the power toggle switch on the bottom of the mouse is ON/OFF, and it must be in
the ON state.)
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE：
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement, it can be used in portable exposure
condition without restriction.