Installation guide

INSTALLATION

 Connect the HDTV Inputs

(Optional)

If your VidaBox came with HDTV input(s), you may directly connect them to the

VidaBox’s X ATSC HDTV OTA Input(s). Before doing so, make sure that your

HDTV antenna is installed properly.

If there are no HDTV inputs, skip this section and go to  Connect the Video Output

on page 13

 How many HDTV inputs do you have?

1. One – Go to Connecting Directly from a HDTV Coaxial Cable below.

2. Two – Go to Using a Splitter and/or Amplifier below.

Connecting Directly from a Coaxial Cable:

1. Take your incoming HDTV coaxial cable and plug it directly into the X ATSC

HDTV OTA Input.

2.  Move on to the next section,  Connect the Video Output on page 13

Using a Splitter and/or Amplifier:

1. Take your incoming HDTV coaxial cable and plug it directly into a 1-to-2 coaxial

splitter and/or splitter-amplifier combination device, as shown on the left.

Note: You may wish to use a splitter-amplifier combination device to attain better

video quality. HDTV signals are sensitive to degradation, and may not work if you

are splitting an already weak signal with a 1-to-2 passive splitter.

2. Take the 2 coaxial output cables and plug them into the X ATSC HDTV OTA

Inputs

3.  Move on to the next section,  Connect the Video Output on page 13

1-to-2 coaxial splitter

1-to-2 coaxial

splitter & amplifier device