Full Product Manual

1) Locate the LED driver and prepare for remote installation within the
junction box.
2) Using UL recognized wire nuts connect the building power wires to
the LED driver.
3) Place LED driver into the Junction Box. 4 inch octagon box only.
4) Locate the mounting plate and LED module. Feed the LED module
connector and ground wire through the mounting plate center hole.
5) Connect the LED driver (male connector) to the LED module
(female connector.)
a. IMPORTANT - DO NOT connect fixture to a driver that
is energized/powered on. Connect LED driver to the
fixture before powering on the LED driver.
6) Use UL recognized wire nuts to secure LED module Ground to
building Ground (Earth).
7) Secure mounting plate to junction box with (2) junction box screws.
8) Secure LED module to mounting plate with (2) allen wrench set
screws.
Installation Instructions for Karpo Single Spot
Disconnect the product from the
power supply before cleaning or
maintenance.
LINE
NEUTRAL
JUNCTION BOX
JUNCTION BOX
SCREWS
To prevent electrical shock, turn off electrical breaker and branch circuit switch.
Article Number CCT Canopy Dimensions
702250U/51U/52U/53U 3000K
Ø:108mm x H:13mm
702254U/55U/56U/57U 4000K
INSTALLATION STEPS
This luminaire must be installed in accordance with the National Electrical Code and
local electrical and construction regulations. To assure full compliance with local code
and regulations, check with your local electrical inspector before installation.
Do not install if luminaire, parts, or connectors are damaged.
Product must be installed with provided drivers and housings only. Use of other
manufactures components will void warranty.
Safety Information
Ø: 30mm x
H: 115mm