Full Product Manual

Installaon Instrucons for Parry 3 Surface Spot & Wash linear
SAFETY INFORMATION
is luminaire must be installed in accordance with National Electrical Code and
local electrical and construction regulations. To assure full compliance with local
codes and regulations, check with your local electrical inspector before installation.
1.
To prevent electrical shock, turn o electricity at fuse box before installation.
2.
3.
Do not exceed product specied luminaire voltage.
Any other source will void warranty.
Do not install if luminaire, parts or connectors are damaged.
4.
Product must be installed with provided drivers and housings only. Use of other
manufacturers’ components will void warranty.
5.
MAINTENANCE AND CARE:
Disconnect the product form the
power supply before cleaning or
maintenance.
Warning:
is product contains chemicals known to the state of California to cause cancer, birth defects, and/or other
reproductive harm. oroughly wash hands aer installing, handling, cleaning, or otherwise touching this
product.
R
Phone: [phone]
Fax: [phone]
2016-21-09
1.- Connect 120VAC(White & Black) leads from Junction box to
(White & Black) leads of LED Driver.
2.- Connect 120VAC ground wire from J-Box to bracket ground wire.
3.- Place LED Driver into junction box
4.- Align slots of round mounting plate up with 2 threaded mount point of
junction box and add screws to secure round plate to J-Box.
5.- Connect the LED Driver.
6.- Add canopy and secure with screws on surface of canopy.
6mm
OFF
20mm
POWER
20W
120V
60Hz
Ø 2.75in x 5.5in
LED, 1600 Lm
3000K, CRI 90
712060U /61U
1.2 lbs
712070U /71U
6
4
1
5
3
2
Page 1 of 1
5022 Joanne Kearney Blvd.
Tampa, FL 33619