User Manual
Table Of Contents
- General Notice
- Safety Precautions and Warnings
- 1 Getting Started
- 2 Diagnostic Operations
- 3 Common Special Services/Functions
- 3.1 Oil Light Service/Reset
- 3.2 ABS bleeding
- 3.3 Battery matching
- 3.4 Electronic Parking Brake (EPB) Service
- 3.5 Diesel Particulate Filter (DPF) Regeneration
- 3.6 TPS(Throttle Body Alignment)
- 3.7 Steering Angle Sensor (SAS) Calibration
- 3.8 TPMS Adaptation
- 3.9 Immobilizer
- 3.10 Injector Coding
- 3.11 Gear Learning
- 3.12 Suspension Match
- 3.13 Sunroof Initialization
- 3.14 Gearbox Match
- 3.15 Ajuste Fuel
- 3.16 Odometer Calibration
- 3.17 AFS (Adaptive Front Lighting System)
- 4 OBDII/EOBD Diagnostics
- 5 Playback Data
- 6. Software Update and Printing
iAuto Series Scan Tool User Manual V1.0
13
History codes are also referred to as past codes that indicate intermittent DTCs that are not
currently active.
1. Select Read Codes from Function Menu and press the OK key. A code list including code
number and its description displays.
2. Use the up and down arrow keys to scroll through data to select lines, and left and right arrow
keys to scroll back and forth through different screens of data.
2.3.2 Erase Codes
Erase Codes menu lets you to clear all current and stored DTCs from a selected control module.
Also it erases all temporary ECU information, including freeze frame. Erase Codes does not fix
the problem that caused the fault! DTCs should only be erased after correcting the condition(s)
that caused them.
1. Select Erase Codes from Function Menu and press the OK key. Follow the on-screen
instructions to complete the procedure.
2.3.3 Freeze Frame Data
Freeze Frame Data menu displays freeze frame data, a snapshot of critical vehicle operating
conditions automatically recorded by the on-board computer at the time of the DTC set. It is a
good function to help determine what caused the fault.