User Manual

iAuto Series Scan Tool User Manual V1.0
23
When the monitor’s status is:
●
OK - vehicle was driven enough to complete the monitor.
●
INC (Incomplete) - vehicle was not driven enough to complete the monitor.
●
N/A (Not Applicable) - vehicle does not support that monitor.
There are two types of I/M Readiness tests:
●
Since DTCs Cleared - shows status of the monitors since the DTCs were last cleared.
●
This Drive Cycle - shows status of monitors since the start of the current drive cycle.
Below is a list of abbreviations and names of OBD II monitors supported by the code reader.
To retrieve I/M Readiness Status data :
1. Scroll with UP/DOWN key to highlight I/M Readiness from Diagnostic Menu and press the
OK key. If vehicle supports both types of monitors, a screen for monitor type selection displays.
Select a monitor type and press the OK key.
2. If the vehicle is tested supports both types of monitors, following screen displays.
3. Depending on readiness test, one of these 2 screens will be present. Use the up and down
arrow keys to scroll through data. Press the ESC key to exit.
No.
Abbreviation
Name
1
MIS
Misfire Monitor
2
FUE
Fuel System Monitor
3
CCM
Comprehensive Components Monitor
4
CAT
Catalyst Monitor
5
HCAT
Heated Catalyst Monitor
6
EVAP
Evaporative System Monitor
7
AIR
Air Conditioning Refrigerant Monitor
8
O2S
Oxygen Sensor Monitor
9
HRT
Oxygen Sensor Heater Monitor
10
EGR
Exhaust Gas Recirculation System
Monitor