User Manual
Table Of Contents
- General Notice
- Safety Precautions and Warnings
- 1 Getting Started
- 2 Diagnostic Operations
- 3 Common Special Services/Functions
- 3.1 Oil Light Service/Reset
- 3.2 ABS bleeding
- 3.3 Battery matching
- 3.4 Electronic Parking Brake (EPB) Service
- 3.5 Diesel Particulate Filter (DPF) Regeneration
- 3.6 TPS(Throttle Body Alignment)
- 3.7 Steering Angle Sensor (SAS) Calibration
- 3.8 TPMS Adaptation
- 3.9 Immobilizer
- 3.10 Injector Coding
- 3.11 Gear Learning
- 3.12 Suspension Match
- 3.13 Sunroof Initialization
- 3.14 Gearbox Match
- 3.15 Ajuste Fuel
- 3.16 Odometer Calibration
- 3.17 AFS (Adaptive Front Lighting System)
- 4 OBDII/EOBD Diagnostics
- 5 Playback Data
- 6. Software Update and Printing
iAuto Series Scan Tool User Manual V1.0
2
3) User’s Manual - instruction on tool operations.
4) Password Paper - provides serial no and password of each tool.
5) Memory Card - Used to store data and to upgrade the scan tool
6) Blow molding case - stores the scan tool and its accessories
7) Software CD - contains update client and user manual.
1.3 Specifications
Display: Backlit, 4.3” TFT color display
Working Temperature: 0 to 60 ℃ (32 to 140℉)
Storage Temperature: -20 to 70℃ (-4 to 158℉)
Power Supply: 8-18V vehicle power, 12V AC/DC power, 3.3V USB power
Tool Dimensions: 209*117*47mm (L*W*H)
Gross Weight: 1.0 Kg/1.4Kg(iAuto710&iAuto730)
Protocols: ISO15765(CANBUS 11bit&29bit TP16,TP20,UDS,FIAT CAN,VOLVO
CAN),ISO14230(KWP2000),ISO9141-2,J1850VPW,J1850PWM,KWP1281,
KWP2089,KW81,KW82,ALDL,SCI,DSI,DSII,LUCAS,MELCO,BENIX, ISO7800,
SIMENMS_ISO1,SIMENMS_ISO2,MIT MODE1,MIT MODE2,Mitsubishi Negative Logic
protocol,Nissan-specific protocol.
1.4 Preparation &Connections
1.4.1 Preparation
--Turn the vehicle ignition to ON position.
--Vehicle battery voltage should be 9~14 volts
--Throttle should be on a closed position.
1.4.2 Connecting to Vehicle
1. Locate the data link connector (DLC). The DLC is generally a standard 16 -pin connector
located 12 inches from the center of the steering wheel, under or around the driver’s side.
2. Plug the diagnostic cable into the vehicle DLC socket.
3. The scan tool automatically boots up.
1.5 System Setup
The System Setup functions allow you to adjust default settings and view information about the
scan tool. Options are :
●
Language
●
Unit
●
Beep Set
●
Key Test
●
LCD Test
●
About
●
Shortcuts