NTI NETWORK Tel:330-562-7070 TECHNOLOGIES 1275 Danner Dr INCORPORATED Aurora, OH 44202 Fax:330-562-1999 USB-SUN USB TO SUN ADAPTER INSTALLATION / USER GUIDE MAN015 REV 11/23/01
Introduction T h e N T I U S B - SUN is a USB to SUN adapter that allows users to easily connect their SUN USB enabled computer to an NTI Universal Multi Platform (ST-xU) or Universal Matrix (ST-n X m - U ) K V M S w i t c h . Parts Included 1 1 NTI USB-SUN Adapter USB-AB-0,5M-5T USB AB male-to-male cable Cable that may be required but is not supplied: Application Connect adapter to NTI Universal Switch NTI CABLE SKTINT-xx-MM Legend: xx is the length of the cable in feet.
Setup When using the USB-SUN adapter to connect to an NTI KVM switch: 1. Connect one male 8 pin minDIN end of the SKTINT-xx-MM cable to a female 8 pin minDIN Keyboard and Mouse input port on the NTI KVM switch being used (see Fig. 3). Switch the power ON to the KVM switch if it isn't already. 2. Connect the other male 8 pin miniDIN end of the SKTINT-xx-MM cable to the 8 pin m i n i D I N f e m a l e p o r t o n t h e U S B - S U N adapter. Mating Face of a 8 Pin miniDIN Female Fig. 3 3.
PLEASE NOTE: It is necessary to configure the host (Sun) computer such that the Sleep Mode is not enabled. If the host computer goes into sleep mode either automatically or manually, the user must reboot the host computer in order to resume use of the host computer. To disable the Sleep Mode, perform the following steps: 1. Select "Power Manager" 2. Look for "Device Idle Time Before Power Saving Starts" 3. Select "Always ON" 4. Look for "Override Device Idle Time For:" 5.
