Operation Manual

Switching on and off

Before switching on for the first time, check all connections and ensure that

the volume on your amplifier is turned down.

Push and release the Power button to switch the unit on or off. The LCD

display will light up when the unit is switched on.

Note If you leave the unit switched off for an extended period (around two

weeks or longer) you may need to re-tune the unit to restore the available

services.

You should now perform the tuning operation described below.

Using your DRX-601ESM

This section provides information on using the main functions of your DRX-601ESM including tuning,

selecting a service and altering the displayed information.

Tuning

Tuning the DRX-601ESM is very simple. In most cases you only need to

perform this operation once, when you first set up the unit. The tuning

facility has two modes:

Rapid - scans frequencies in the UK channel allocation. This should take

less than a minute.

Full - scans the full range of digital frequencies in Band III. This may take

several minutes.

1. Ensure your DRX-601ESM is switched on and your aerial is

connected and positioned correctly.

2. Push and release the Autotune button once for rapid mode and

twice for full mode. Note You can cancel Autotune by pushing the

Autotune button again during the tuning process.

The display will indicate tuning is underway. When finished, the

name of the first service found will be shown on the top line of the

display and you will hear it through your speakers. All the services

found are now stored in the unit and you can select a service as

described below.

Note

If no services are found the display will show the message NO

ENSEMBLES. Check your aerial connection and positioning and try the

tuning process again.

You may want to repeat this procedure in the future if you change your aerial

position or if you want to receive a newly introduced service.

Note If reception is poor, check the signal strength and try repositioning

your aerial using the signal strength indicator as described on page 9.