Operation Manual

Switching on and off
Before switching on for the first time, check all connections and ensure that the volume is turned down.
Push the power switch on the side of your DRX-601EX to the I (on) position to switch the unit on or to the 0 (off)
position to switch the unit off. The LCD screen will light up when the unit is switched on.
You should now perform the tuning operation described below.
Using your DRX-601EX
This section provides information on using your DRX-601EX including tuning, selecting a service and altering the displayed information.
Tuning
Tuning the DRX-601EX is very simple. In most cases you only need to perform this operation once, when you first set
up the unit. The tuning facility has two modes:
Rapid - scans all frequencies in the UK channel allocation. This should take less than a minute.
Full - scans the full range of digital frequencies in Band III. This may take several minutes.
1. Ensure your DRX-601EX is switched on and your aerial is connected and extended.
2. Push and release the Autotune button on the front of your DRX-601EX once for rapid and twice for full mode.
Note You can cancel Autotune by pushing the Autotune button again during the tuning process.
The display will indicate tuning is underway. When finished, the name of the first service found will be shown
on the top line of the display and you will hear it through the speakers. All the services found are now stored in
the unit and you can select a service as described below.
Note If no services are found the display will show the message NO ENSEMBLES. Check your aerial connection and
positioning and try the tuning process again.
7
Note If reception is poor, check the signal strength and try repositioning your aerial using the signal strength
indicator as described on page 9.
You may want to repeat this procedure in the future if you change the unit or aerial position or if you want to receive a
newly introduced service.