Operation Manual

14
Troubleshooting
This section gives some of the most likely solutions to problems you might have with your DRX-601EX.
I can’t get any sound
Make sure your DRX-601EX is plugged in and switched on as explained on page 7.
Check that the source selection switch on the side panel is set to RADIO.
Check that the volume is not set too low and that you have not selected MUTE on the remote control, see page 11 for details.
Ensure that you have completed the Autotune procedure to find digital radio services as explained on page 7.
Remote control not functioning
Check that you have inserted the batteries correctly.
Check that you are not too far away from the main unit (not more than 7 metres recommended).
Check that the remote sensor on the main unit is not obscured.
Check if the Remote indicator LED lights up indicating that the remote signal is being received.
Display says ‘No Service Check Setup’
Check that your aerial is connected and extended. Use the Autotune facility to search for services. Try using the Full search as explained on page 7.
I can’t access secondary services
At the time of publishing not many secondary services are available. If secondary services are available for the currently selected service the
Secondary indicator LED will light up. You use the remote control to select secondary services, see page 11 for details.
Display says ‘Memory Reset Presets Lost’
This may occur if the unit has been switched off for an extended period of time (longer than two weeks). Use the Autotune feature as described on
page 7 to refresh your stored services if necessary. You can then re-enter your presets using the remote control, as described on page 10.