Installation Instructions

The terms HDMI, HDMI High-Definition Multimedia Interface,
and the HDMI Logo are trademarks or registered trademarks
of HDMI Licensing Administrator, Inc.
KM2 PLUS
KM2 PLUS
KM2 PLUS
物料刀模名称
公司名称 深圳市视壮科技有限公司： V-SPP220413C2 订单号：
物料名称 说明书
KM2 PLUS
100x103mm
兰正孟
± 2mm
80G书纸
AV1P.DUNS05.01
3009KM2PXXX1
/
Ver 1.0
/
黑色印刷
折叠方式：风琴折后对折
2022.4.16
/
/
双面印刷
： 版本号：
物料料号：
图号 ：
对应机型： 特殊工艺： 需求材质：
印刷工艺 过膜类型：印刷色需求：
成品尺寸： 尺寸公差：
审核：设计人员： 设计日期：
：
备注：
专色色号：
：
1. On your Android phone, open
the pre-installed app “Google”
2. Type or say,“OK Google, set up
my device”
3. Tap 4K Androi... (529) on the list
Press Back to cancel
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Statement
WIFI & Bluetooth
his equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems.
The device shall automatically discontinue transmission in cases of absence of
information to transmit, or operational failure. Then it will scan the available radio
signals. If this signal is connected before, it will be automatically connected, otherwise
manual connections will be necessary.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 7.9 inches between the radiator & your body. This transmitter must
not be co‐located or operating in conjunction with any other antenna or transmitter.
WIFI & Bluetooth settings will be displayed during FTI.