User manual

User Manual ADPRO
®
XOa Client Software
106 21796_05_preliminary
as the alarm is active. When the system detects the end of alarm, it does not send a new message
indicating that the alarm is no longer active. Note that you cannot switch off the repeat alarm.
The profile type is 3 – Fire verification. Note that you cannot modify the profile type of the standard alarm
profiles.
12.4.10 Fire Trouble Profile
The fire trouble profile is used with fire detection systems. You use it to send fault messages to all
transmission destinations when there is a fault in the fire detection system. The profile sends messages in
both armed and disarmed states. It sends the message again every 15 minutes as long as the fault is active.
When the system detects the end of the fault condition, it does not send a new message indicating that the
fault is no longer active. Note that you cannot switch off the repeat alarm.
The profile type is 4 – Fire trouble. Note that you cannot modify the profile type of the standard alarm
profiles.