Owner's manual

EN - English - Instructions manual
3
1 About this manual
Before installing and using this unit, please read this
manual carefully. Be sure to keep it handy for later
reference.
1.1 Typographical conventions

DANGER!
High level hazard.
Risk of electric shock. Disconnect the
power supply before proceeding with any
operation, unless indicated otherwise.

WARNING!
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully and
carry it out as instructed.

INFO
Description of system specifications.
We recommend reading this part carefully
in order to understand the subsequent
stages.
2 Notes on copyright and
information on trademarks
The quoted names of products or companies are
trademarks or registered trademarks.
3 Safety rules

The manufacturer declines all responsibility
for any damage caused by an improper use
of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves
the right to modify its contents without any
prior notice. The documentation contained
in this manual has been collected with great
care, the manufacturer, however, cannot
take any liability for its use. The same thing
can be said for any person or company
involved in the creation and production of
this manual.
• The device must be installed only and exclusively
by qualified technical personnel.
• Before any technical work on the appliance,
disconnect the power supply.
• Do not use power supply cables that seem worn
or old.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook: improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
• Use only original spare parts. Not original spare
parts could cause fire, electrical discharge or other
hazards.
• Before proceeding with installation check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels ("4.2 Product markings", page 3).
4 Identification
4.1 Product description and type
designation
This housing is suitable for a variety of cameras (1/2”,
1/3” and 1/4”) equipped with a wide range of lenses.
Constructed from extruded and die-cast aluminium.
Its weatherproof feature is ensured by the EPDM-
rubber gaskets and by 3 cable glands. The use of the
cable management bracket gives a total vandal-proof
protection to the power and video cables. A wide
range of accessories is available: sunshield, normal
and fan-assisted heater, blower and camera power
supply.
Further, it is also possible to install a blower with an
air filter replacing one cable gland. The accessories
are supplied factory installed or as a simple upgrade
kit.
4.2 Product markings
See the label attached to the outside of the package.