User manual

Installation

Vidikron Vision 70 Series Owner’s Operating Manual 37

PRE

IMINAR

Configure Lens Motor Trigger: CineWide with AutoScope maintains constant image height

independent of the aspect ratio, while using the full display resolution of the projector. It

accomplishes this by moving the anamorphic lens in front of the primary lens when

widescreen material is being viewed. When the viewer transitions back to 16:9 or 4:3 source

material, the anamorphic lens moves out of the light path.

To configure the lens motor trigger on the Vision

70 for proper AutoScope operation:

1. Press ME

NU on the remote control.

2. Select Service from the Main menu and press ENTER.

3. Use the number buttons on the remote to enter the Service menu passcode when

prompted and press ENTER aga

in. Then, press MENU on the remote control.

4. Select Screen Trigger Mode from the Service menu.

5. Set the Screen Trigger Mode to “Trigger.” This enables the lens motor to mov

e the

anamorphic lens into position (in front of the

primary lens) when the Cinema or Cinema

Fill aspect ratio is selected.

6. Select the Cinema or Cinema Fill aspect ratio to

move the anamorphic lens into position,

if it isn’t already. To do this, press CINEMA or C-FILL on the Vision 70 remote control

(Figure 2-4).

Adjusting the Horizontal (X) Lens Position:

1. Project a white field on the screen.

2. Loosen the Yaw/X-Adjustment Levers underneath the lens.

3. Slowly move the anamorphic lens into place so that there are no shadows on either side

of th

e screen:

4. When the horizontal position is properly set, tighten the Y

aw/X-Adjustment Levers to

secure the lens in place.

Too Far Right

Too Far Left

Correct position