PEX Installation Manual
Table Of Contents
- 1 Introduction
- 2 Codes, Standards and Certifications
- 3 Viega PEX Installation Methods
- 4 Viega Manifolds
- 5 Viega PEX Press Fittings
- 6 Viega PEX Crimp Fittings
- 7 ViegaPEX Ultra Tubing
- 8 Viega FostaPEX Tubing
- 9 Viega PEX System Design and Sizing
- 10 System Sizing and Calculations
- 11 Water Service Installation
- 12 Installing the ManaBloc
- 13 Mounting the ManaBloc
- 14 Installing Manifold Distribution Lines
- 15 Installing the ViegaPEX Ultra Tubing System
- 16 Fastening the Viega PEX System
- 17 Installing Viega PEX Fittings
- 18 Pressure Testing Viega PEX Systems
- 19 System Disinfection
- 20 Warranty
9
IM-PF 724596 0416
3.3 Branch and tee
This method of plumbing is commonly referred to
as a conventional plumbing system or branch-and-
main systems.
This system uses a large-diameter “main” supply
line for both hot and cold water supplies that runs
throughout a structure to or near each fixture
group, with smaller “branch” lines teeing off the
main to supply each fixture.
• Ideal for condensed oor plans
• Less installation time
Branch-and-Tee Installation
Connections High
Installation Time Low
System Efciency Low