Instructions
17
-
gerechnet wird.
Fahrstufenwert 4
x
Wert 4
x
Beispiel:
116, es wird also alle 5
x
Stufe 44 insgesamt 28 Schritte zu machen sind,
wird dies also in 28
x
-
denn die Beschleunigung belastet den Stromspei-
cher zusätzlich. Umgekehrt bleibt die Beschleuni-
gung unter Umständen aus, wenn der Stromspei-
cher trotz schlechten Kontakts dennoch nachgela-
den werden kann.
Strecke kann der Sound automatisch leiser gestellt
erkennt, dass die Kontaktgabe zum Gleis schlecht
Tipp:
-
-
-
-
bessern.
6. Wartung
-
nenfahrzeugmodell haben, ist eine regelmäßige
Wartung unerlässlich. Bitte beachten Sie die folgen-
-
tungsschritte durch.
Achtung:
Vollständige Wartung des Fahrzeugs alle 25 Be-
triebsstunden.
in case of poor contact. The internal value 4 of the
internal speed table corresponds to speed step 3
while the internal value 11 corresponds to speed
step 5. Now simply enter the fourfold value in CV
115 since the decoder works internally with a four
times ner resolution.
Then the decoder accelerates from the internal
speed step 4
x
4 = 16 to the new internal value of
4
x
11 = 44. With CV 116 you can adjust the rate
of acceleration for increasing the internal values in
steps of 10 milliseconds.
Example: If you write the value 5 into CV 116, then
the decoder will increase the value every 5
x
10 ms
= 50 ms by one internal speed step. Since there
are 28 steps in total between the internal step 16
and 44, the increase will take place within 28
x
50
ms = 1.4 seconds.
Do not enter very small values for this time because
acceleration means additional strain on the power
storage module. On the other hand it may happen
that there will be no acceleration if the power stor-
age module is charged despite poor track contact.
If you wish to extend the distance that can be
covered without contact to the tracks you can turn
the sound volume down or even switch o the sound
completely whenever the decoder detects poor
track contact. This feature can be adjusted with CV
118. Also refer to the CV table on pages 12 – 15.
Hint:
You can set the distance after which the model
starts braking in a track sector without power in
steps of 0,5 cm with CV 119. You can also adjust
the braking distance with CV 120.
Performance can be optimised even further pro-
vided the track voltage in digital mode is denite-
ly higher than 16 V. Enter the value 85 in CV 125
for enhancing the eectiveness of the energy stor-
age device.
6. Maintenance
Regular maintenance provides you with much
enjoyment with your rail vehicle model for many
years. Please observe the following remarks and
carry out the maintenance work as described reg-
ularly.
Attention:
Full maintenance is required after every 25 hours
of operation.