User manual

3
Fig. 2
Abb. 2
Fig. 1
Abb. 1
rt gn rt ge
gn
ge
ws
rt1
gn
rt2
ws
gn1
gn2
ge1
ge2
Wichtig: Widerstände und Diode an den
Enden der Anschlussdrähte sind für die
Funktion erforderlich. Entfernen Sie diese
keinesfalls! Umhüllen Sie die Widerstän-
de nicht mit Isolationsmaterial, da sie sonst
keine ausreichende Kühlung erhalten!
Signalbegriffe
Die Signalbegriffe der Lichtsignale zeigt Abb. 2.
Nicht jedes Signal kann jeden Begriff darstellen.
Bezeichnung der Signale
Beigelegt ist eine Tafel mit Klebebildern (nur bei
Signalen mit r.-Tafel) zur frei wählbaren Bezeich-
nung der Signale. Informationen zur vorbildge-
rechten Beschriftung nden Sie im Signalbuch.
4. Montage
1. Bohren Sie an der Montagestelle ein Loch.
Durchmesser: H0, TT: 5,5 mm / N, Z: 4 mm
2. Führen Sie das Anschlusskabel von oben
durch das Montageloch und stecken Sie dann
das Signal mit dem Patentsteckfuß hinein.
Das Signal muss nun fest sitzen, lässt sich aber
bei Bedarf leicht herausziehen und demontieren.
Attention: Resistors and diode at the end
of the wires are essential for the function of
the signal. Never cut off the resistors or
the diode! Don’t cover the resistors with
isolation material because they need to be
cooled by air.
Signal aspects
Figure 2 shows the aspects of the daylight signals.
Not every signal can show every aspect.
Marking of signals
Adhesive signs are supplied with the signal. Sim-
ply cut out the desired sign and attach it to the
signal box after removing the protecting foil. The
signalbook provides you with helpful information.
4. Mounting
1) Drill a hole at the mounting place.
Diameter: H0, TT: 5.5 mm / N, Z: 4 mm
2) The signal‘s connection wires have to be insert-
ed into the hole rst. Then put the signal with
the patented Viessmann-socket into the hole.
The signal has to set tight on it’s position but you
can unmount it easily.
Hp0 „Halt“
Blocksignal
Block signal
Ausfahrsignal
Exit signal
Einfahrsignal
Entry signal
Vorsignal
(Hauptsignalbegriff
erwarten)
Hp0 + Sh1
„Zughalt
+ Rangieren
erlaubt“
Hp2
„Langsamfahrt“
Hp1 „Fahrt“
Vr0 Vr1 Vr2