Technical information

Installation of Vitocontrol-S, VD2/CT3-MW1
Control Installation Continued
1
3
2
1 Control mounts to tabs at top of
control harness. Hang control on
tabs upper edge.
2 Allow control to pivot
downwards and fasten control to
control harness using supplied
screws.
3 Install the front of the control
onto the rear housing. Press
downwards to ‘Click’ the front
cover and rear housing together.
When installed properly, the
front will be allowed to pivot
upwards without separating from
rear of control.
“Click”
Section 2
Section 2.4
Plug in quick-connect plugs into
sockets with corresponding
numbering. To avoid any miswiring
of control, refer to electrical section
of this wiring overview.
IMPORTANT
14
5346540 v1.0 09/2006 Technical information subject to change without notice