Technical information

Installation of Vitocontrol-S, VD2/CT3-MW1

Control Installation Continued

1 When the control is ready to be

closed, the front housing can be

fastened down with three

screws (supplied). Ensure there

are no pinched wires between

the rear portion of the control.

2 The junction box cover is used to

protect and enclose the control

harness DIN rail.

Weave front cover edge between

tabs on junction box.

Pivot the cover closed and

securely tighten the holding

screw.

Section 2

Section 2.4

5346540 v1.0 09/2006 Technical information subject to change without notice