Operating instructions

32
Function/system components Code
Adjust Delivered con-
dition
Operation with LPG 82:1 82:0
System only with two heating circuits with mixer with
extension kit for mixer (without unregulated heating
circuit)
■ with DHW cylinder 00:8 00:10
■ without DHW cylinder 00:7 00:9
System without DHW circulation pump:
Heating circuit pump A1 connection at internal exten-
sion H1 or H2
53:2 53:1
System with DHW circulation pump:
Heating circuit pump A1 connection at extension
AM1, terminal A1
— 33:1
DHW circulation pump termination at extension AM1,
terminal A2
— 34:0
System with low loss header 04:0 04:1
Adjusting the heating curves (only for weather-compensated
control units)
The heating curves illustrate the relation-
ship between the outside temperature
and the boiler water or flow tempera-
ture.
To put it simply, the lower the outside
temperature, the higher the boiler water
or flow temperature.
The room temperature, again, depends
on the boiler water or the flow tempera-
ture.
Note
If the heating system includes heating
circuits with mixers, then the flow tem-
perature of the heating circuit without
mixer is higher by a selected differential
(8 K in the delivered condition) than the
flow temperature of the heating circuits
with mixers.
The differential temperature can be
changed at coding address 9F.
Settings in the delivered condition:
■ Slope = 1.4
■ Level = 0
Commissioning, inspection, maintenance
Further details regarding the individual steps
(cont.)
5692 857 GB