Operating instructions

Cleaning the combustion chamber/Cleaning the heating sur-

faces and installing the burner

1. If required, clean combustion

chamber and he ating surfaces A

withabrushorflushwithwater.

Important information

Scratches on parts which

are in contact with flue

gases, can lead to corrosion.

Only use plastic brushes

and NOT wire brushes.

Apply a solvent-/potassium-free

cleaning agent if residues remain:

Remove soot deposi ts with alka-

line cleaning agents with addi-

tional surfactants (e.g. Fauch

600).

Remove coatings and surface

discolouration (yellow-brown)

with slightly acidic, chloride-free

cleaning agents based on phos-

phoric acid (e.g. Antox 75 E).

Thoroughly flush with water.

Note

Fauch 600 and Antox 75 E are sup-

plied by

Hebro Chemie GmbH

Rostocker Straße 40

D 41199 Mönchengladbach

c: Intec Basser sdorf AG

Grindelstrasse 12

Postfach

CH-8303 Bassersdorf

2. Install the burner and torque nuts

diagonally with 4 Nm.

3. Secure the g as supply pipe with a

new gasket.

Further details regarding the individual steps (cont.)

Initial start-up, inspection, maintenance

5692 548 GB