Technical data

OPERATION AND FUNCTIONS
1 To use the autotune function through the front panel
controls, you must press the AUTOTUNE button. The unit
will search for a higher frequency with a proper signal.
Press and hold the AUTOTUNE button for two seconds,
and the unit will search for a lower frequency with a proper
signal.
2 You can also activate the autotune function through the
remote control.
On the display you can see that the frequency increases or
decreases. When the tuner has found a channel, the tuning
process will automatically stop, and the sound from the
channel found will be heard.
If no channels are found, you must check if the antenna has
been correctly connected and adjusted.
To activate the manual tuning function press the TUNING +/-
on the front panel or UP or DOWN buttons on the remote
control.
If you wish to save the found station to preset then please
press the desired preset number 1-10 on the remote control
for 2-3 seconds.
Note:
If you want to listen to stations from the FM band that have
not been preset you must tune them again either manually or
Automatically.
Automatic tuning
Manual tuning
Reset
This tuner can be reset. This is used to delete channel stored
in the unit.
Press and hold the INFO button for two seconds. Press the
INFO button once again until the display shows the message
SYSTEM RESET, and the press Enter. All stored channels
has now been removed from the unit.
1
18
FM tuning
The offers both manual and automatic tuning on the FM band.
This makes it possible to save just one specific channel. It also makes it possible to adjust the supplied
antenna for the best possible signal.
VIETA HRE75B
1
IN F O
BR O WS E SA VE
IN F O
BR O WS E SA VE
2
2
1
IN F O
EN T ER BR O WS E SA VE
IN F O
EN T ER BR O WS E SA VE