Operation Manual

GB GB
Bardot Operation Guide
21
Bardot Operation Guide
20
2. Once the scanning is complete the DAB/DAB+ stations will be displayed in alphanumeric order. The rst
station in the list will be selected.
Note: if no DAB/DAB+ signal is found in your area, it may be necessary to relocate your radio to a
stronger signal area. Websites such as www.ukdigitalradio.com in the UK feature handy postcode
nders that will tell you what DAB channels you can expect to receive.
Selecting another DAB/DAB+ Station
While a program is playing, turn the –TUNING + knob to cycle through available stations, and then press
the –TUNING + knob to conrm the station you want to play.
Updating the Stations List
Press the MENU button, turn the –TUNING+ knob to select Full scan, and then press the –TUNING + knob
to conrm. Scan will commence.
Displaying Signal Strength
While playing a DAB/DAB+ program, repeatedly press the INFO button until the display shows a signal bar
indicating the strength of the current station.
Manual Tuning
1. Press the MENU button, turn the –TUNING+ knob to select Manual tune, and then press the
–TUNING+ knob to conrm. The display will show the channel number and frequency.
2. Turn the –TUNING+ knob to step through the channels and then press the –TUNING+ knob to select the
current channel.
Note: If there is a multiplex corresponding to this channel and frequency, then after a few
seconds the display will show a tuning meter with the signal strength and the multiplex.
Getting Started
Carefully remove your Bardot from its box. You may wish to store the packaging for future use.
Inside the box you will nd:
- Your Bardot
- Power Adapter with plugs for UK and mainland Europe
- User Manual
Positioning your Bardot
Place your Bardot on a at / stable surface, with reference to the safety information section in this manual.
Adjusting the Aerial
The aerial should be extended to ensure you receive the best signal possible in both DAB and FM radio
modes. Later on it may be necessary to alter the position of your Bardot and its aerial to achieve the best
reception.
Turning the Unit On and Off
1. Connect the plug at the end of power adapter cable to the DC in jack on the back of your Bardot. Insert
the power adapter into the mains socket.
2. Turn the mains power on and then press the POWER button to turn on the unit.
Pressing the POWER button again switches your Bardot to standby mode. To switch the unit off
completely, unplug the power adapter from the mains socket.
Volume Control
Adjust the radio volume by turning the – VOLUME + knob.
Using DAB Mode
Note: When you turn on the radio it will automatically search and store all the available
stations. You should conduct an additional Full Scan to ensure all stations are picked up and
stored. It is also recommended every few months to run a new scan to pick up any new DAB/
DAB+ stations that may have begun broadcasting after purchasing your Bardot.
1. Repeatedly press the SOURCE button until DAB is shown on the display. For the rst time your Bardot
will carry out a full scan and store a list of stations in memory.