Operation Manual

GB GB

Retro DAB+ Operation Guide

TECHNICAL SPECIFICATIONS

Positioning, Preparing and Switching on

Positioning

A good place for your Retro DAB+:

- has a at and stable surface with sufcient ventilation

- is within 1.4metres of a power socket if you are using mains power.

- has space above it for you to fully extend the telescopic aerial vertically.

- is away from bright sunlight, heat sources, humidity and dampness.

Preparing

- If using mains power: connect the mains power lead into the socket on the back of the radio (DC IN).

Switch the mains power wall socket off. Now plug the power adaptor into the wall socket, and switch

the wall socket on.

- If not using mains power, ensure new batteries are correctly tted. Your Retro DAB+ can be powered

by four type ‘C’ alkaline or rechargeable batteries (not supplied). When using batteries to power the

unit, function and operation are the same as using the mains, except that a docked iPod/iPhone will

not be charged. A low power symbol will display when batteries are running low, and your Retro DAB+

will return to standby mode when almost out of power. If operating on batteries, please switch of the

mains adaptor and remove the mains power plug from the back of the radio.

- Fully extend the radio aerial vertically for the best reception.

Switching on

- When switching on for the rst time, slide the power switch on the back of the radio to “ON”.

What you will see when you switch on

- “View Quest” will be displayed for 2 seconds, followed by the clock. This is ‘standby’ mode.

- After 10 seconds the display backlight will switch off.

Leaving and entering standby mode

- Press (1) to switch between working and standby mode. In standby mode the display shows a clock,

in working mode the display shows information about the current function.