Operation Manual

GB GB
Retro DAB+ Operation Guide
25
Retro DAB+ Operation Guide
24
Alarm Sounds
- If the alarm is set to DAB/DAB+ mode and no DAB/DAB+ stations can be received, BEEP Tone1
will sound.
- If the alarm is set to “iPod” mode and there is no iPod connected, BEEP Tone1 will sound.
- Whether “iPod” or “BEEPER” alarms are sounding, docking or removing an iPod or iPhone will
turn off the alarm.
- If two alarms are set, when ALARM 1 is sounding and ALARM 2 begins to sound, it will
automatically turn off ALARM 2.
Alarm Volume
Whichever alarm mode is selected, the alarm volume will be half the maximum volume.
Sleep Timer
You can send your Retro DAB+ to sleep for up to 90 minutes time.
In working mode, press and hold SNOOZE (9) to enter sleep function setting. The display will show ‘Sleep
Timer‘ with “OFF” ashing on the lower right. Press (4) or (6) to select sleep time from 15min,
30min, 45min, 60min or 90min. Press (5) to conrm your selection.
Sleep time will be displayed as ‘Snn’ on the upper right of the screen, where ‘nn’ is the sleep time selected.
To cancel the sleep timer, follow instructions above and select ‘off’ instead of a sleep time.
Other Operations
Your Retro DAB+ has two functions that you are only likely to need in the unlikely event of a problem while
in conversation with support.
Factory Reset
[Note] Factory Reset will cancel all your presets
In working mode, press and hold “MODE” button until “Press Enter Key to Reset” is displayed.
Then press (5) to conrm. “System Reset, then System Reset OK” will display.
Software Version
In working mode, press and hold INFO to check the software version.
5. Set alarm time hours by pressing (4) or (6). Press (5) to conrm hours setting and go on to
minutes.
6. Set alarm time minutes by pressing (4) or (6). Press (5) to conrm hours setting and go on
to alarm type.
7. Set alarm type by pressing (4) or (6). Sources are:
- BEEP Tone 1
- BEEP Tone 2
- DAB
- FM
- iPod
8. Press (5) to conrm alarm type setting.
9. In Standby mode your Retro DAB+ will show bell symbols and numbers to show which alarms are active.
To show alarm status
In either standby or working modes press SNOOZE( 9) to select ALARM 1. Press it again to select ALARM
2. In either case the status of the alarm will be displayed:
Stopping or snoozing the alarm
When alarm goes off you can press (1) to turn off the alarm
Press SNOOZE (9) to snooze for 5 minutes. Your Retro DAB+ will enter into Standby mode and show the
clock. You can repeat snoozing for a maximum period of 1 hour.
Snoozing multiple alarms
Only one alarm can be snoozing at a time. If ALARM 1 is snoozing ALARM 2 will also automatically snooze if
it begins to sound. ALARM 1 snooze will be cancelled.