Butler Quick Start Guide
EN Slots and accessoires DE Anschlüsse und Zubehör EN DE 1. ADD BUTLER IN THE CMS 1. BUTLER IM CMS ANLEGEN Setup Go to devices and add Butler in your viewneo account. 2. CONNECT BUTLER Connect Butler with the power supply and if needed, the LAN cable. Wait until the blue light appears to indicate that it is successfully connected. 3. SETUP HOTSPOT 2x ANTENNAS 1. Antenna 2. Ethernet 3. Power 4. Reset UNIVERSAL AC ADAPTOR The Butler will automatically create a hotspot: viewneo_butler_.
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Reorient or relocate the receiving antenna. · · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
HELP AND SUPPORT HILFE UND SUPPORT Need help with viewneo® Cloud or viewneo® hardware? Find detailed information, FAQs, tutorials and downloads at support.viewneo.com. Du brauchst Hilfe mit viewneo® Cloud oder viewneo® Hardware? Auf support.viewneo.com findest du Infos, FAQs, Tutorials und Downloads. © 2019 viewneo® viewneo® is a trademark of Adversign Media GmbH www.viewneo.
