User's Manual
Table Of Contents
- Instruction
- Product
- System Configuration
- Installation
- Setting
- Calibration
- Diagnosis, Inspection and Maintenance
- Troubleshooting
- Regulatory Information
- Medical Equipment Safety Standards
- Radio Frequency Compliance Information
- Labels and Symbols
- Guidance and Manufacturer’s Declaration for EMC
- Electromagnetic Emissions
- Electromagnetic Immunity
- Electrostatic Discharge (ESD) IEC 61000-4-2
- Electrical Fast Transient/Burst IEC 61000-4-4
- Surge IEC 61000-4-5
- Voltage Dips, Short Interruptions/Voltage Variations on Power Supply Input Lines IEC 61000-4-11
- Power Frequency (50/60 ㎐) Magnetic Field IEC 61000-4-8
- Conducted RF IEC 61000-4-6 / Radiated RF IEC 61000-4-3
- Information
Rev.1.0
Page 100 of 151 VW40-152-009
VIVIX-S 1012N User Manual
6.2 Detector Configuration
From the Detector Configuration dialog, you can configure the detector and check the images before or
after doing calibration.
Function
Description
Detector Direction Compensation
Set
s the displayed direction of image.
Effective Area
Set
s effective area of an image.
Offset Refresh Setting
Set
s conditions of automatic Offset Refresh.
Time Interval (min.)
Checks cycle of temperature change
Temperature Interval (℃)
Differ
ence of over-temperature.
Number of shot
Number of Offset Refresh.
Masking (On / Off)
Set
s outside of the effective area to specific values.
OSF
Chooses whether to use OSF or not.
Set
S
aves the setting values to the detector.
Pan
Moves an image to the desired location.
Zoom
Extends or
constract an image.
W/L
Adjusts window level of an image.
Fit
Displays an image by adjusting it to the screen.
E.A.
Sets
the effective area of an image with a mouse.
ROI
Sets the image area of interest.
E.A (Effective Area)
Displays effective area of
an image only.