User's Manual Part 1

Rev.1.5 Page 72 of 121 D-16-207
VIVIX-S 1417N User Manual
4 To supply power, connect the DC power cable to the DC power input port of SCU mini.
4.2.3 Booting up SCU (Ex. FXRS-03A)
1 Turn on the power switch at the front side of SCU.
2 Check if the power switch of SCU lights up green.
3 Check if the status indicator is blinking in green after the power switch of SCU is permitted.
4 Check if the status indicator of SCU is blinking in green and turns to light up in the same color.
 When the power switch lights up green, it means that the power is applied normally.
 When the status indicator is blinking in green, the SCU is booting.
 If the status indicator lights up green, it indicates that the SCU is being operated normally
after booting up.
4.2.4 Booting up the Detector
 The procedures in this chapter are explained according to the default setting status of a
detector (factory reset) and the use of wireless connection.
 Refer to <5.3.3 Wireless Initialization of Detector> for the detailed information about the
default setting status of a detector.
1 Attach a charged battery pack to the detector.
2 Press the power button of the detector for 1 second until the power LED is turned on.
3 When the power LED is on, check if it is lit green.
4 Check if the active LED is lit orange on the detector.