User's Manual Part 2

Rev.1.5 Page 98 of 121 D-16-207
VIVIX-S 1417N User Manual
6.1.6 The Active LED and Data LED of the Detector are blinking
Category
Description
Symptom
 The active LED and data LED are blinking while power LED is turned ON.
Expected Causes
 Detector registeration error
 Data transmission error
Solutions
1 Turn on SCU again.
2 Check the network cable connection.
3 Check the workstation environment and network information again.
4 Check if the surrounding wireless communication is good.
5 Check cable connection again when connected with tether interface cabel
6 Replace other devices and check the result of it
7 Replace corresponding devices.
6.1.7 Errors in Detector LED
Category
Description
Symptom
 All LEDs of a detector are blinking.
 Two LED lamps of a detector are blinking and the remaining one is blinking slowly.
Expected Causes
 Internal hardware errors of a detector.
Solutions
1 Reboot the detector and check the result.
2 Replace the detector to another one.
6.1.8 Rapid Consumption of Battery
Category
Description
Symptom
 The fully-charged battery is consumed rapidly.
Expected Causes
 The performance of a detector is decreased by its length of use.
 In case of using a battery under in low temperature.
Solutions
1 Replace a battery pack if it is used for a long time. (Battery pack is consumables.)
2 Use a battery pack at room temperature. Charging capacity of a battery pack is
decreased in low temperature.
6.1.9 Battery Pack or Installation Part of Battery is Getting Hot
Category
Description
Symptom
 A compartment for installing a battery pack is getting hot.
Expected Causes
 A battery malfunction
 Detector failure
Solutions
1 Stop using a battery pack.
2 Contact the service engineer in Vieworks.