User's Manual Part 2

Rev.1.5 Page 76 of 121 D-16-207
VIVIX-S 1417N User Manual
2 Connect one end of the LAN cable to the LAN port of SCU Lite, and connect the other end to the LAN
card connector of workstation assigned for data transfer.
3 Connect the DC power adaptor to the power input port of SCU Lite.
4.2.7 Booting Up SCU Lite and Detector
1 Turn on the power switch at rear side of SCU Lite.
2 Check if the LINK LED of SCU Lite lights up green.
3 Check if the power LED of the detector lights up in light green.
4 Check if the active LED of the detector lights up in light green.
 When the LINK LED of SCU Lite lights up green, it means that the power is approved
normally.
 The detector starts booting up when you turn on the power of SCU Lite.
 Refer to <5.3Product Initialization> for the detailed information about the default setting
status of a detector.
 If the power LED of the detector does not light up, check if the tether interface cable is
connected to the PoE port of SCU Lite correctly.