User's Manual Part 2

Rev.1.5 Page 77 of 121 D-16-207
VIVIX-S 1417N User Manual
4.3 Device Setting
4.3.1 Software Installation
1 After connecting all devices, prepare the following softwares to set, calibrate and operate the detector /
SCU.
Software
Description
VIVIX Device Driver (VDD)
Image filter driver for acquiring images from a detector.
VIVIX Setup
A program for setting and managing the detector / SCU.
2 Install VIVIX Device Driver and VIVIX Setup in sequence.
 It is not necessary to install VIVIX Device Driver and VIVIX Setup separately in case of
installing the VXvue program made by Vieworks.
3 Configure environment for the workstation.
4.3.2 Setting Detector and SCU
1 After executing VIVIX Setup, access to the detector and SCU to set each device properly.
2 Perform detector calibration to acquire images suitable for the installation environment.
3 Take radiographic images to check if the shooting is conducted normally.
4.3.3 Setting NFC Tag

To change the all detector settings by using NFC tag at once, you need to register Preset Configuration
and set connection with the NFC tag to use from VIVIX Setup in advance.

If you already set the NFC tag, you can change it to the Preset Configuration by contacting it on the
contacting part of NFC located at the rear of the detector.

The NFC mode is only to adjust settings and are not used simultaneously with Wi-Fi mode.