User's Manual Part 2

Rev.1.5 Page 81 of 121 D-16-207
VIVIX-S 1417N User Manual
4.4.3 Wireless Communication Diagnosis
1 Execute VIVIX Setup and go to the Information tab of the Diagnosis dialog.
2 Check the status of wireless communication from the Network item.
 You can also check the communication status from VXvue or VIVIX SDK.
 Refer to VIVIX Setup Operation Manual for the detailed information about the wireless
communication diagnosis.
Strength of Wireless Communication Signal
Stage
Level
Status LED
Link Quality
Meaning
Very Good
5
66 ~ 70
The wireless communication is running smoothly, and it
ensures the image acquisition.
Good
4
56 ~ 65
Normal
3
41 ~ 55
The wireless communication status is normal, but it does
not ensure performace of the image acquisition.
Bad
2
31 ~ 40
The wireless communication status can become unstable.
Very Bad
1
1 ~ 30
Impossible to make wireless communication normally.
Unknown
0
0
Impossible to get the wireless communication status, or
the system is not connected wirelessly.
 The communication cannot run smoothly when the strength of wireless communication is
under the level 2. Therefore, it is required to check the surrounding wireless
communication status.
 In case of using the detector under wireless communication, be sure to check the
communication status before starting to use the detector. If the status is bad, the speed
of acquiring images will be very slow or you may fail to acquire images.
 Be sure to check the surrounding wireless communication to prevent communication
interference. If wireless communication module in the detector has any problems, contact
the service engineer in Vieworks.