Service Manual

Rev.1.0 Page 44 of 90 D-19-616
VIVIX-S VW Service Manual
3.3 System Configuration
This section gives information about the configuration modes of VIVIX-S VW detectors, SCU, workstation
and the generator.
3.3.1 SCU AP Mode
In SCU AP mode, the detector and the SCU mini (FXRS-04A) are connected wirelessly, and the SCU mini
and PC are connected by wired.
SCU mini & Detector

SCU and the detector are connected wirelessly. In this case, SCU operates as AP (Access Point) and
detector as STATION.

Basically, the detector is powered by a battery. However, when you connect the AC-DC adapter to the
detector, it receives power from the adapter and the battery charges quickly.
 The SCU mini (FXRS-04A) supports IEEE802.11n and has two antennas. Therefore, SCU AP
mode is IEEE802.11n / MIMO 2x2, so the data transfer rate is up to 300Mbps.
 Le SCU mini (FXRS-04A) prend en charge IEEE802.11n et possède deux antennes. Par
conséquent, le mode SCU AP est IEEE802.11n / MIMO 2x2, de sorte que le taux de
transfert de données peut atteindre 300 Mbps.
SCU mini & PC (Workstation)

SCU and PC (Workstation) are connected with the LAN cable.
SCU mini & X-ray Generator

SCU and the X-ray generator can be connected with a generator interface cable. (DR trigger mode)