Service Manual

Rev.1.0
Page 62 of 90 D-19-616
VIVIX-S VW Service Manual
4.2 Device Setting
4.2.1 Software Installation
1
After connecting all devices, prepare the following softwares to set, calibrate and operate the detector /
SCU.
Software
Description
VIVIX Device Driver (VDD)
Image filter driver for acquiring images from a detector.
VIVIX Setup
A program for setting and managing the detector / SCU.
2
Install VIVIX Device Driver and VIVIX Setup in sequence.
It is not necessary to install VIVIX Device Driver and VIVIX Setup separately in case of
installing the VXvue program made by Vieworks.
Il n'est pas nécessaire d'installer VIVIX Device Driver et VIVIX Setup séparément pour
installer le programme VXvue créé par Vieworks.
3
Configure environment for the workstation.
4.2.2 Setting Detector and SCU
1
After executing VIVIX Setup, access to the detector and SCU to set each device properly.
2
Perform detector calibration to acquire images suitable for the installation environment.
3
Take radiographic images to check if the shooting is conducted normally.
The device setting should be done by an engineer who understands the VIVIX Setup,
Windows system, wired/wireless network and the related technique. If not, an error could
occur while operating the detector, or the image quality could be affected.
Le réglage du périphérique doit être effectué par un ingénieur comprenant la
configuration VIVIX, le système Windows, le réseau câblé / sans fil et la technique
associée. Sinon, une erreur pourrait survenir lors de l'utilisation du détecteur ou la qualité
de l'image pourrait en être affectée.