Service Manual

FCC Compliance



This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
Operation is subject to the following tow conditions.

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause
undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measure.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from where the receiver is connected.

Consult the distributor or an experienced radio/TV technician for help.
RF Exposure Statement :
The equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operation in conjunction
with any other antenna or transmitter.
This Mobile device has been evaluated for and shown compliant with the FCC RF Exposure limits.
The unit of measurement for RF exposure is Specific Absorption Rate (SAR). The FCC SAR limits for
mobile is 1.6W/Kg per 1g of tissue. For the SAR values specific to your device, see the Quick Start Guide
or User Manual.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.