Installation guide

RS232 daisy-chain connection

1. Make sure the ID number has been set for each display.

2. Connect the computer to a display using a RS-232C serial null modem cable.

3. Connect all displays using the RS-232C serial null modem cables.

4. Go to Setting > Control Setting each display. Select RS-232C.

5. Refer to the RS-232 protocol document.

LAN connection

1. Connect the computer to a LAN switch or hub using a RJ45 cable.

2. Connect all displays separately to the same LAN switch or hub just connected

with your computer using RJ45 cables . Now the computer and all displays are

within the same local area network.

3. Make sure the network connection is enabled.

4. Go to Setting > Control Setting each display. Select LAN. Refer to the user

manual of the purchased model for the detailed settings and the operation of LAN

control.