Main Firmware Upgrade Notice

Table Of Contents

IFP7550 Firmware Upgrade Notice

Check the current firmware version:

1. Boot up the IFP7550, then press the following front keys VOL+  VOL-  SETTINGs  HOME. This will

open up the DEBUG MENU.

2. Click “Software Information”.

3. Check the Date information.

If the date is 2018-12-11 or after: The IFP7550 firmware does not need to upgrade. Click “Back” to

return to the DEBUG MENU then click “Exit”.



PAGE 1
IFP7550 Firmware Upgrade Notice Check the current firmware version: 1. Boot up the IFP7550, then press the following front keys VOL+  VOL-  SETTINGs  HOME. This will open up the DEBUG MENU. 2. Click “Software Information”. 3. Check the Date information. If the date is 2018-12-11 or after: The IFP7550 firmware does not need to upgrade. Click “Back” to return to the DEBUG MENU then click “Exit”.
PAGE 2
If the date is before 2018-12-11: The IFP7550 firmware needs to upgrade. Click “Back” to return to the DEBUG MENU then start your firmware upgrade. Prepare a USB drive: 1. Click “IFP7550 Main Firmware” download link to download “IFP7550_20181211_122548.ZIP” from web site. 2. Unzip the file then you will get “upgrade_510” folder. 3. Format your USB drive into FAT32. 4. Copy the “upgrade_510” folder to the root of the USB drive. 5. Insert the USB drive into the USB2.0 port that is near HDMI 1 and HDMI out.
PAGE 3
4. Click “Confirm” to upgrade firmware. 4. The power key will flash to signal that the firmware is being upgraded. The screen will restart once the firmware upgrade has been completed.  5. IFP7550 will run setup wizard. NOTE: Make sure that you DO NOT POWER OFF and DO NOT TOUCH THE SCREEN while the device is upgrading. It will damage the main board permanently. Disclaimer: ViewSonic Corporation assumes no liability for any errors or omissions in the information displayed.